Technologies & process

Opto-electronic engine based on LED Light

Opto-electronic technology for blood sensors based on multiple LED sources and wide spectrum detectors

In this technology section, a medical sensor works in combination with a disposable cuvette, in order to monitor online the oxygen saturation, hematocrit, hemoglobin and blood temperature, with the aim of continuously providing information on the blood condition.

More +

These sensors are based on an opto-electronic engine which uses solid-state light sources LED at four different wavelengths for the measurement of oxygen saturation and hematocrit.
The measure of both oxygen saturation and haematocrit is based on a ratiometric principle of measured scattered light at these wavelengths.

Other light source LEDs are used for the status/error code detection. For temperature measurement an IR-sensor integrated thermopile is implemented.

Blood leakage detection sensors are categorized in this technology. They are devices based on an opto-electronic engine which uses two solid-state light sources LED in the UV (Ultraviolet) and IR (Infrared) range.

Opto-electronic engine based on fluorescence

In this technology section, a medical sensor works in combination with a disposable cuvette and a sensor spot, in order to monitor the partial oxygen pressure and the blood temperature, with the aim of continuously providing information on the blood condition.

More +

This sensor measures partial pressure of Oxygen (pO2) via an optical fluorescence technology.
The light from an LED excites the oxygen sensitive element embedded in the arterial sensor spot to emit fluorescence: the sensor measures the decrease/quenching of the fluorescence signal and correlates the degree of quenching to the arterial oxygen partial pressure of the blood.
Reduction of fluorescence lifetime corresponds to an increase of the oxygen concentration, allowing the quantification of free oxygen in blood to get pO2 (mmHg).
For temperature measurement an IR-sensor integrated thermopile is implemented.

Strengths of Datamed products

Customization

Both hardware and firmware

Sensors 100% blood calibrated

All devices are individually calibrated in bovine blood circuit

Plug & Play

There is no need to perform any calibration when used in field

Compact design and embedded software

Data is directly transmitted to the monitor, no external calculations are needed

Mounted on principal arterial or venous line

Not on shunt lines

Our process

1

Customer needs analysis

As a first step, an analysis of customer’s needs is performed when a request from the market comes. The analysis consists of understanding if we can meet the customer’s request with a ready-to-use sensor or if it involves a hardware and firmware customization 

2a

Off-the-shelf product: ready to use

If the request coming from the market can be satisfied, in all the necessary features and functionalities by a Ready to use Sensor, we proceed with a sales quotation, which can also include a custom calibration.

2b

Opto-electronic engine on the shelf product

If the customer’s needs cannot be met by our off-the-shelf sensors, a detailed analysis is performed and the following aspects are defined in collaboration with the customer:

  • Intended use and relative application field
  • Sensor features: measurement range and accuracy
  • Responsibilities
  • Preliminary timeline and deliverables
  • Estimation of development and final products cost
2b.1

HW input     

Datamed provides inputs and support development of the HW. It evaluates and verifies the design and first prototypes.

2b.2

HW Designer

Datamed designs by itselfs the HW of both device and cuvette. It follows the molds development.

3b

FW development

Datamed develops custom FW according to specific internal protocols and customer requirements

4b

Custom calibration and validation

Datamed develops a custom calibration procedure for each blood sensor type to reach the defined measurement ranges and accuracies. 

The complete manufacturing and calibration process, together with the FW, are validated by a dedicated plan.

5b

Design Transfer and Mass production

Once the development phase is completed and the product is validated, a design transfer to the production factory site is performed in order to start the device mass production. A first article inspection is performed on the initial mass production.